stillcom.blogg.se

1. SET FRANSON GPSGATE FOR ALL USERS HOW TO
2. SET FRANSON GPSGATE FOR ALL USERS INSTALL
3. SET FRANSON GPSGATE FOR ALL USERS SOFTWARE
4. SET FRANSON GPSGATE FOR ALL USERS TRIAL

SET FRANSON GPSGATE FOR ALL USERS SOFTWARE

If you only checked the second box above it should create 4 virtual COM ports which you can now use with other software as if they were separate GPS devices.Īt this point, your basic setup is finished. GpsGate will then show you a summary of the settings it has enabled. I am only selecting the second choice as I do not use nRoute or MapSource, but if you do, you may wish to leave that checked. GpsGate will then ask you to select the outputs you want your GPS stream to be passed on to.

SET FRANSON GPSGATE FOR ALL USERS HOW TO

You can try the search again or check out the bottom of this entry on how to find what COM port your device is using. If GpsGate was unable to locate your device, make sure it is plugged in and turned on. Hit Next and GpsGate will start looking for devices plugged into your system.Īfter it finds a compatible device, it will ask you if you want to use it. In my case, I am using a NMEA compatible device, so if I desired, I could uncheck everything but the third box. You can keep all those clicked, or just check the ones that apply to you, either way it doesn’t hurt to let it search. When you start GPSGate for the first time you are greeted with the GpsGate Setup Wizard:

SET FRANSON GPSGATE FOR ALL USERS INSTALL

Other GPS pucks may have driver installation media that is necessary for you to install first. The Globalsat BU-353 is plug and play so it should work right away. After you have installed GPSGate, plug your GPS receiver into one of your available USB ports and run GPSGate.

SET FRANSON GPSGATE FOR ALL USERS TRIAL

If you download the Express version it comes with a 14-day free trial of the Standard version for evaluation, so you can use that time to figure out if this is going to work for you. If you have not downloaded GpsGate Splitter, do so at the link above. You need the standard edition to get the logging capabilities I refer to in this post.įirst thing is first. The Express version is free and it will support output to two devices, however it will not log. GpsGate Splitter Standard runs $39.95 and is definitely worth the money. Most chasers are familiar with this software as it allows them to send their GPS data to GR3, Streets & Trips, etc, all at the same time. GpsGate Splitter allows you to take the NMEA stream from your GPS device and send it to multiple programs simultaneously.

As long as you get one that outputs a NMEA-0183 compatible data stream, you should be good to go. You do not need to use this particular puck if you do not want to. You can usually pick one of these up for about $30. I’ve never had a single issue with it and it always picks up a strong signal.

There are a couple of things that I use to do this, and if you have alternative methods, please post in the comments! The next couple of posts in this series will describe what to do with those logs after the chase! To start this blog off, I’ll show you what I do to collect GPS data everytime I boot up my laptop without having to remember to start logging.

Not only that, but with some special software I can even create watermarks with the location and timestamp of the photo! This is part 1 of a series of blog entries that will show you what I do with my GPS data and how you can do it, too! I also use it to geotag the photos I take so I can always say exactly where I shot a particular photo.

I use my GPS data to create travel maps and compile chase statistics. Aside from having a historical record of my trip, keeping a GPS log enables you to do all kinds of cool stuff after the fact. Well, as long as I bring the laptop, anyway. This way, no matter what, I’ll always have a GPS log of wherever I went on any given day. Being a data junkie, one of the things I like to do is log my GPS stream everytime I hook it up. Whether it be a personal nav device, a phone with GPS or a separate GPS puck they use with street atlas software. Almost every storm chaser has a GPS device in their vehicle.